- On-Road Vehicles
- Off-Road Vehicles
- Ready To Ship Vehicles
- Most Popular Parts & Accessories
- Search All Parts & Accessories
- Tools & Testing
- Covers
- Accessories
-
Parts
- Bearings
- Bolts & Washers
- Brackets & Mounts
- Cables & Levers
- Clutches, Parts & Covers
- CV Axles
- Drive Belts
- Drive Shafts & Parts
- Electrical
- Engine Parts
- Fuel Parts
- Fuel Pumps
- Full Exhaust & Parts
- Gaskets, O-Rings & Kits
- Intake Parts
- Spark Plug Covers
- Spark Plugs
- Steering Racks & Parts
- Suspension, Kits & Springs
- Filters & Fluids
- Brakes
BAR-HARNESS II BLACK 28" WIDECD1
|
$24.43
|
MPN # 28505
- The Canyon Dancer Bar Harness gives you a place to attach tie downs to a motorcycle or scooter that is high and wide for good support
- Keeps your tie downs away from expensive paint and plastic and bodywork
- A hassle-free way to secure motorcycles for transport
- The closed end design prevents the cups from creeping inward and damaging bodywork
- Sized to fit even the fattest grips in the industry
- The new cups makes the bar-harness even easier to install correctly
- Injection molded polycarbonate cups are reinforced with stainless steel D-Ring "lay-ins" for added safety
- Break testing shows the Bar Harness II to withstand pulling forces over 1800 pounds per each side
- The webbing and stitch patterns have shown to be stronger than the best coated-wire tie down hooks in the industry
- Fits bars up to 28" wide
- Black
Warning: NEVER start engine with harness installed. NEVER install harness on loose or bent bars. NEVER install harness on any part of the motorcycle except the grips at the ends of the bars. NEVER install harness on handlebars higher than four inches above the top triple clamp or handlebar clamp except as additional stabilization. NEVER leave the harness installed on rubber mounted bars for an extended length of time (weeks) except when used as an additional stabilizer and other tie-downs are used to support the total weight of the motorcycle. NEVER compress the front forks more than halfway or approximately two to three inches. NEVER pull down on the straps hard enough to bend your handlebars or your bar-end weight bolts. Extra caution should be used when using ratchet tie downs. NEVER install the harness on motorcycles with extended forks (such as choppers). These warnings are for our protection! Don't ignore them and blame problems on the harness.
